1. Parker CZPT pump T6 Solitary Vane Pump
2. Design T6E, T6ER, T7ERS, T6ERM T7ES, T6EM T7ES, T7BS T7E T7ES T7DS T7DRS,
T6C, T6CM T6CR T6CRM T6CRM T6CR,
T6D, T6DM T6DR, T6DMY T6DRMY T6DRM
3. Interchangeable Vane Pump cartridge displacement as comply with:
T6C vane pump: 003, 005, 006, 008, 571, 012, 014, 017, 571, 571, 571, 571, 031
T6D vane pump: 014, 017, 571, 571, 571, 031, 035,038, 042, 045, 050
T6E vane pump: 042, 045, 050, 052, 057, 062, 066, 072, 085
T7E vane pump: 042, 045, 050, 052, 057, 062, 066, 072, 085
four. Function below.
The high pressure vane pump incorporates the layout of vane pin holdout.
They are applicable for these hydraulic machineries that demand substantial rotation strain and lower sounds level.
The vane pump sequence are developed for purposes in die casting devices, injection molding devices and other special development equipments.
CZPT fluid: Before beginning undertaking plHangZhou, you should refer to our info sheets RE 95710 (mineral oil), RE 95711 (environmentally acceptable hydraulic fluids) and RE 95713 (HF hydraulic fluids) for detailed info with regards to the decision of hydraulic fluid and software problems.
The right decision of hydraulic fluid demands expertise of the operating temperature in relation to the ambient temperature: in an open circuit the tank temperature. The hydraulic fluid must be decided on so that the working viscosity in the operating temperature selection is in the the best possible range – the shaded spot of the choice diagram. We advised that the larger viscosity class be chosen in each and every scenario. Instance: At an ambient temperature of X°F (X°C) an functioning temperature of 140°F (60°C) is set. In the ideal running viscosity variety (shaded spot) this corresponds to the viscosity courses VG 46 or VG 68 to be picked: VG sixty eight.Remember to be aware: The case drain temperature, which is afflicted by strain and pace, is always higher than the tank temperature. At no stage in the method may possibly the temperature be larger than 240°C (115°C) for dimensions 5 to two hundred or 195°F (90°C) for measurements 250 to 500.If the previously mentioned problems cannot be maintained owing to severe functioning parameters, we recommend flushing the circumstance at port U (dimension 250 to 500).